IceCap Heater Controller

IceCap Heater Controller

UPC:
6974415981121
Weight:
30.00 Ounces
Shipping:
Calculated at Checkout
Model:
ICE98112

Your Price is :
$65.99

Earn Points

Aquarium Heater Controller

The IceCap heater controller can connect up to two heating elements (sold separately) and provides precise temperature control for an aquarium. It includes dual-heating power jacks and supports up to 1000 watts. For added safety, you can use it in conjunction with an aquarium system controller.

Features

  • Dual grounded output heater control
  • Accommodates a combined total of 1000 watts
  • Accurate heat control
  • For freshwater and marine aquariums
  • 1-year limited warranty

Specifications

Temperature Control Modes: On/Off Control, Heating
Temperature Control Range: 20-34°C / 68-93°F
Temperature Resolution: 0.1°C / 32°F
Temperature Accuracy: ±1°C / ±1°F
Ambient Temperature: <35°C / 95°F
Audible Alarm: Over Temperature Alarm
Input Power: 100 ~240VAC/60Hz
Relay Contact Capacity: Heating (10A, 100-240VAC)
Controller Body Dimensions: 3.125in x 5.375in x 1.125in (LxWxH)
Probe Cord Length: 5ft
Heater Outlet Cord Length: 18in
Calibration Offset: ± 5.0° (C/F) in 0.5° increments

Heater controller only - Requires a proper-sized heater(s) to operate.
For Indoor use only

 

Controller Temperature Calibration

Check the aquarium's water temperature on the thermometer against the temperature shown on the Heater Controller. If there is a large difference between the thermometer and the Heater Controller, you must calibrate it. 

  1. Press and hold <+> and <-> buttons simultaneously for around 3 seconds. The Water Temp display will begin blinking.  The original allowance value shows at 0.0. 
  2. Press <+> or <-> button to adjust up or down the value ± 5.0° (C/F) in 0.5° increments
  3. Finally, press the Set button to confirm calibration setting. The bottom display will change back to show the water temperature

 

WARRANTY